Hummingboard & CuBox-I Software

Hummingboard & CuBox-I Software

 

Hummingboard and Cubox-I Software

You can either DIY
or

purchase our SD card
where you select from a list of pre-installed SD card distributions

 


Do it your self with Ignition Boot Loader


Ignition is the CuBox-i and HummingBoard simple installer. It's main intention is to easy the installation of a selected set of distributions from the Internet.
It is by itself a small distribution that should first be flashed to an SD card. Once booted, Ignition can be used to choose the distribution that you want to install. This should simplify the process if a distribution is not available as a separate disk image.
Getting started

Download Ignition from here http://download.solid-run.com/pub/solidrun/Ignition-imx/
Flash it to an SD card. Ignition is very small, if you want to override it with a distribution in the installation process, make sure that the SD card is large enough to fit the distribution that you wish to install
Make sure that the CuBox-i is connected to a monitor/TV via HDMI, USB keyboard or mouse.
Installation is done only from the Internet; so either wired or wireless connectivity is required.
Place the SD card in the CuBox-i and power it on
Using Ignition

After a successful boot, the install menu will be shown. In case Cubox-i or HummingBoard are connected through the wired network (Ethernet) then it will DHCP to get IP address and present distribution list.
In case of wireless, then click on Setup wifi and configure wireless connectivity.
Select the distribution from the list and press the Install button.

Distributions that can be installed using Ignition
Ignition is the CuBox-i installer to install a distribution.

Click Here for a list of distributions then can be installed using Ignition.


 

Show:
Sort By:

300Mbps Mini Nano Wifi 802.11n Wireless LAN USB Network Adapter

NEW ARRIVAL!300Mbps Mini Nano Wifi 802.11n Wireless LAN USB Network Adapter Dongle    ..

AUD $19.50